Beyond FlipScreen Guide d'installation télécharger pdf (Page 4)

RPSB 1800/1802 Installation Guide

Image Side-to-Side Adjustment

Tighten the screws that secure the top of the platform when the correct position is achieved.

Tilt the projector platform to make the image level.

Use the zoom lens or move projector to expand/contract the image.

1. Use the projector's zoom lens to adjust image size. Zooming in or out may be

sufficient to expand or contract the square of light to fill the SMART Board.

Move projector on platform

or use projector zoom

Image Size Adjustment

Move projector on platform

or use projector zoom

Image Size Adjustment

KEYSTONING

NOTES

•

If the image is keystoned along the sides

−

that is, the side margins are different

widths (see the figure on the next page)

−

you may need to raise or lower the

front or back of the projector slightly.

•

If the image is keystoned along the top or bottom (the sides of the image are not

of equal length), the projector is not positioned properly at a right angle to the

small front mirror. You may need to move only the back of the projector side to

side to correct the image.

2. You may be able to make minute adjustments to the projector’s position with the

projector’s built-in software, using a remote control or buttons on the projector. Refer

to your projector’s manual for details.

3. Repeat the procedures described above as necessary.

- Loosen both knobs

- Tilt platform

- Tighten both knobs

to maintain new position

Roll Adjustment

1 2 3 4 5 6 7 8 9 ... 21 22

Pas de commentaire

Beyond FlipScreen Guide d'installation Page 4